Due to the light weight and high strength of steel structure, it is suitable for factory construction. But do you know how to build the wall panel of workshop steel structure? Next, Guangtong steel will explain it to you.

The installation of workshop steel structure is very important, so the type, specification and quality of steel structure materials should meet the planning requirements and relevant national production level, and sampling and review should be carried out before use.

1. Measure the actual length of the installation plate, and cut the plate according to the measured length and the plate length of the corresponding plate number when necessary.

2. Place the board lifted to the roof according to the starting line, align the board width covering mark line with the starting line, and discharge the designed construction length at both ends of the board length direction.

3. After fastening both ends with fasteners, install the second plate. The installation sequence is from left to right or from right to left, from top to bottom.

4. Install to the next setting out sign, recheck the deviation of plate installation, when it meets the design requirements, fully fasten the plate, if it can not meet the requirements, adjust in the next sign section, and fully expand the installation at one time.

5. When installing the core plate, the gap between the plates should be compacted, and the position should be accurate. When there is still a gap, the insulation material should be used to fill.

6. When installing composite plates on site, the upper and lower layers of steel plates shall be laid according to the method mentioned above, and the insulation surface shall be laid continuously.

7. The wall after installation shall be checked for missing fastening points in time, and the gap of the insulation wall shall be filled with insulation materials.

8. When imprisoning the self tapping screw, the tightening degree should be controlled, and it should not be excessive. Excessive tightening will cause the sealing ring to turn up, or even the plate surface to be concave, and there will be water accumulation. If the tightening is not in place, the sealing will not be in place and there will be rain leakage.

9. For the longitudinal overlap of the plate, the sealing strip and sealant shall be laid according to the design, and the lap joint shall be connected with self tapping screw or rivet with sealing gasket, and the fastener shall be pulled at the sealing strip.

Dalian Guangtong Steel Structure Co., Ltd. is an enterprise specialized in steel structure manufacturing. The company covers an area of 18000 square meters, including 13000 square meters of plant area. At present, Guangtong steel products include steel structure column, beam, steel equipment platform, workshop steel structure, light steel villa, etc. Our company has always advocated "safety first, quality first, green production", put product quality in the first place. Strictly control the quality of raw materials and products before leaving the factory, with high-quality service as the core to meet all the needs of customers.